Juno JCF84181 Uživatelský manuál

user manualFridge-FreezerJCF84181

Problem Possible cause Solution The door does not close tightly orit is not shut properlyCheck if the door closes well andthe gasket is undamaged and

The technical information are situated in therating plate on the internal left side of the ap-pliance and in the energy label.INSTALLATIONRead the &qu

Ventilation requirementsThe airflow behind the appliance must besufficient.min.200 cm2min.200 cm2Installing the applianceCaution! Make sure that the m

44mm4mm4. Attach the appliance to the niche with 4screws.I5. Remove the correct part from the hingecover (E). Make sure to remove the partDX, in the c

8. Disconnect the parts Ha, Hb, Hc and HdHaHbHcHd9. Install the part Ha on the inner side of thekitchen furniture.ca. 50 mmca. 50 mm21 mm90° 90°

HaK8 mm13. Place the small square on the guideagain and fix it with the screws supplied.Align the kitchen furniture door and theappliance door by adju

212720711-00-01042010 www.electrolux.com/shop

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Control panel 4First use 4Daily use

Warning! Any electrical component(power cord, plug, compressor) must bereplaced by a certified service agent orqualified service personnel.1. Power co

Service• Any electrical work required to do the serv-icing of the appliance should be carried outby a qualified electrician or competent per-son.• Thi

Important! Do not use detergents or abra-sive powders, as these will damage the fin-ish.DAILY USEFreezing fresh foodThe freezer compartment is suitabl

Humidity controlThe glass shelf incorporates a device withslits (adjustable by means of a sliding lever),which makes it possible to regulate the tem-p

causing frost or ice on the evaporator. Ifthis happens, set the Temperature Regu-lator toward warmer settings to allow au-tomatic defrosting and so a

• rinse and dry thoroughly.Important! Do no t pu ll , move o r d amage anypipes and/or cables inside the cabinet.Never use detergents, abrasive powde

Problem Possible cause SolutionThe compressor operatescontinuallyThe Temperature Regulator maybe set incorrectlySet a warmer temperature The door doe